Putting the FUN in foam flying!

Park Shark

Above are a few pictures of the Park Shark flying as well as a shot of the kit contents (minus the template,  and instructions) .  The Park Shark is a slow flyer suitable for Park and or Indoor Flying.  It is a great trainer and a very easy relaxed flyer.  It's constructed of DOW Bluecore foam (a.k.a. FanFoldFoam).  This is a light weight, durable foam that is easy to work with.  All the parts (except the wing) are CNC Hot wire cut, the wing slot/gear hole in the fuse are cut out with a hand held hot wire using jigs.  The wing panels are oven baked to add strength and lock in the under cambered airfoil, then the main panel and wing tips are cut out using templates, the dihedral angles are also pre-cut via a custom jig.  The kit comes complete with two laser cut control horns and a fully illustrated 22 page instruction/assembly manual.  The instructions are also downloadable for free on the "Downloads" page. 

The nose if made of sandwiched together pieces that make it very strong and simple to build.  The IPS drive is easily replaced if/when the motor burns out.  The wing is removable and held in place with rubber bands.  This greatly aids in storage and transportation.  Fun to fly in up to 8 mph winds.  Loops, wing overs, and power off gliding are a blast!  No matter how many planes I fly, I always come back to and have a great time with my Park Shark.

 Specs

 The AUW (all up weight with two GWS Pico servos, GWS ICS 50 esc, GWS IPS "A" motor/gear drive and 9x7 prop, JR 610 receiver, and a 2.1 oz two cell Lith Poly battery pack)   

Below is a list of items you will need to build and fly the Park Shark

Additionally you will need the following common foam plane building tools and supplies

X-acto knife (with a good sharp blade), scissors, needle nose pliers (or z bend plies for making the bends in your control rods (if your making your own), fine tip Sharpie (or any pen that will mark on foam), packing tape (for hinges and to securely route wires), sanding block with some 150 to 200 grit sand paper (for beveling the rudder and elevator) and some Foam Safe C/A or 5 minute epoxy (or whatever foam safe glue that you prefer to use on your foam planes).

The Park Shark sells for $30.00 US.  Plus actual shipping costs.

Please email me with your shipping address and phone number (Fed-Ex requires a phone number and will not deliver to a P.O. Box) Tell me how many and which type plane you want and I will email you back a total price for the plane (or planes) including shipping from both FedEx Home Delivery, and USPS Priority Mail with Insurance and Delivery Confirmation.  If you would like another shipping method, please let me know and I will check into it and give you a price on that if it's available to me.  I accept payment via PayPal or Money Order.

info@foamtasticmodels.com